Synchronization of remote control

Sometimes you need to re-sync the remote with the engine for various reasons. For example, you may want to use the same remote to control two beds.

Here's how to do it:

1. Start by disconnecting the power supply from the engine by unplugging the bed's power cable. Then leave the motor without power for at least 20 minutes.
2. Connect the power - the motor will now automatically go into synchronization mode for 3 minutes. You can recognize this by the flashing white light of the under-bed lamp.
3. Now take the remote control and simultaneously press the two top buttons "Back up" and "Back down". Press and hold the buttons for three seconds.
4. The longer light signal of the under-bed light will indicate that the remote control is now connected.